DataCard LM200 - Page 69

SR200 & SR300 Card Printers and LM200 & LM300 Laminators User’s Guide 59
TurnOver None
Installed
Displayswhethertheturnover(duplex)optionis
installed.
MG ISOType
 Hico
 Loco
JISType
 Hico
 Loco
RetryConnect
HicoorLocospecifiesthetypeofmagneticstripe
materialbeingusedoncards.
RetryConnectspecifiesthemaximumnumberof
retriesperformedwhenwritingorreadingmagnetic
stripedatafails.
Laminator(doesnotdisplayifnotinstalled)
Mode
 Laminate
 Pass
Displayswhetherthelaminatorappliesmaterialtothe
cardorpassesthecardthroughwithoutlaminating.
Cassette
 None
 Both
 Bottom
 Top
Displayswhichlaminatorcartridgesareloaded.
Film‐T
 Patch
 Overlay
Displaysthetypeoffilminthetopcartridge.
Film‐B
 Patch
 Overlay
Displaysthetypeoffilminthebottomcartridge.
Film‐TPos
‐7,‐6,‐5,‐4,‐3,‐2,‐1,0,1,
2,3,4,5,6,7
Displaysthepatchpositionsettingforthetop
cartridge.
Film‐BPos
‐7,‐6,‐5,‐4,‐3,‐2,‐1,0,1,
2,3,4,5,6,7
Displaysthepatchpositionsettingforthebottom
cartridge.
MenuDisplay Settings Function