23
SP Series Info Central: Troubleshooting
The laminate patch does not
adhere to the trailing edge of
the card.
The supply material was
attached to the take-up spool
and then wound in the wrong
direction.
The next card should process
correctly. If it does not, remove
the cartridge and turn the take-
up spool clockwise several
turns.
The laminate patch is not
centered between the long
edges of the card.
Supply material is not loaded
correctly in the cartridge.
The laminator cartridge is not
fully seated in the printer.
You replaced the laminator
cartridge.
Supply material is wound
unevenly on the supply roll.
The laminator cartridge is
damaged.
Load the laminator supply
correctly.
Push the laminator cartridge
firmly to fully seat it.
The laminator material is self-
centering. Process several
cards without removing the
cartridge to allow the material
to be centered.
If the problem still exists,
change the laminator supply
advance.
Align edges of supply material
on the take-up spool.
Use a new laminator cartridge.
The laminate patch shows
wavy lines along the length of
the card (woodgrain).
The temperature for applying
the supply material is too
high.
Lower the laminator
temperature for this material.
What you see Possible causes Solutions
To Next Page
Loading...
Need help?
General
