Spyder5EXPRESS
Welcome Screen
The first time you run the Spyder5EXPRESS software, you will be greeted with a
Welcome Screen:
There are 4 Checkboxes on this screen:
1) Warm Up
Please make sure that your display has been powered up for at least 30 minutes
prior to doing a calibration.
2) Lighting Conditions
Please make sure that there is no direct light falling on your display as this
could have an adverse effect on your calibration.
3) Display Controls
If your computer has these controls, make sure to set them to the default
settings or equivalent.
4) Spyder Connection
Please plug your Spyder5EXPRESS into a USB port on your computer. Please
avoid using a hub, extension cable, or a port on a keyboard as this could
prevent the Spyder unit from getting the proper data flow.
These checkboxes will only be activated the first time you run the software, the next
time you run the software the reminders will show up, but you will not need to
check the boxes again.
Once you have completed this step, please click the “Next” button in the lower right
corner.
To Next Page
Loading...
Need help?
General
