Datacom DM4380 User Manual

DM4380 – Installation Guide
Logging in for First Time
204.4336.00 - October/2019
32
6 LOGGING IN FOR FIRST TIME
6.1 MANAGEMENT USING CONSOLE INTERFACE
It is possible to access Command Line Interface (CLI) through console interface or by
using a SSH connection from a remote management terminal. To do this, just plug a
compatible console cable and run a terminal emulator as Hyper Terminal or any other
similar using a computer or laptop. The default configuration for DM4380 is baud rate
9600, with 1 stop bit and no parity, following below figure.
Figure 25 – Computer console interface configuration
The DM4380 equipments do not support hardware flow control. In
console port configuration the hardware flow control need to be disabled.
Step 1
 On the PC or laptop, start the terminal emulation program. The
initial login prompt for a username appears:
 DmOS
 DM4380 login:
Step 2
 The default username and password are admin.
 DM4380 login: admin [Enter]
 Password: admin [Enter]
Result
 The prompt as following will appear, indicating a successful login:
 Welcome to the DmOS CLI
 Admin connected from 127.0.0.1 using console on DM4380
 DM4380#
Table 16 – DM4380 Login
6.2 MANAGEMENT USING ETHERNET INTERFACE
Using factory configuration the equipment can be accessed by SSHv2 using
management Ethernet interface (MGMT) through IP 192.168.0.25/24.
With additional configurations is possible to change the default IP and also configure IPs
to access from other Ethernet interfaces. The configuration also allows enabling or
disabling SSHv2 and Telnet servers.

Datacom DM4380 Specifications

General

Brand	Datacom
Model	DM4380
Category	Switch
Language	English