Datacom DM991CE - Equipment Information

Product Manual - DM991 Series V Family - 204.4092.08 43
• R - Exit and reset: The “Exit and reset” option finalizes the terminal access and restarts
the equipment.
10.1. Equipment Information
# --------------------------------------------------------------------------
# D A T A C O M
# DM991C - G.SHDSL Modem - E1 and V.35 Interfaces
# --------------------------------------------------------------------------
# Equipment Information
#
# Product code :[ 3011 ]
# Firmware version :[ 50 ]
# Software boot version :[ 1 ]
# Hardware version :[ 1 ]
# Serial number :[ 278742 ]
# Release date (mm/dd/yy hh:mm) :[ 01/04/06 - 05:52 pm ]
# E2PROM version :[ 1 ]
# Number of after factory resets :[ 56 ]
# Factory code :[ 7 ]
#
#
#
#
#
#
# --------------------------------------------------------------------------
# <ESC> Back
# --------------------------------------------------------------------------
When this option is chosen, the following parameters will be presented:
• Product code;
• Firmware version;
• Software boot version;
• Hardware version;
• Serial number;
• Release date;
• E2PROM version;
• Number of after factory resets - updated at each system reset;
• Factory code;
In the DM991S/SE equipments it is necessary to use the option "E" and wait 10 minutes so the Telebrás
management goes back on.