Datalogic Applications
130 DL-Axist™
To configure a device that is directly connected via USB:
1. Launch DXU.
2. Connect your device to your PC via a USB cable.
3. Click the button for your connected device in the “Available
Device” list.
4. Click the “Configure This Device” button.
5. Configure any settings you wish.
6. Save changes to a configuration file of you do not wish to apply
them to your device.
7. Apply the configuration changes to your device is this is what you
want to do.
To configure a device that is connected over the network (either
Ethernet or Wi-Fi):
1. Launch DXU.
2. Connect your device to DXU manually, using Scan2Pair labels, or
using automatic discovery. (See instructions for these methods
in this section.)
3. Click the button for your connected device in the “Available
Device” list.
4. Click the “Configure This Device” button.
5. Configure any settings you wish.
6. Save changes to a configuration file of you do not wish to apply
them to your device.
7. Apply the configuration changes to your device is this is what you
want to do.
To Next Page
Loading...
