Datalogic Dragon M101 - DRAGON M Configuration

DRAGON™ M SERIES
5
DRAGON™ M CONFIGURATION
DRAGON™M/OM-DRAGON™ STAND ALONE SETUP
When the OM-Dragon™ cradle is connected and powered, configure the
Dragon™ M by reading the following codes in the given sequence and follow the
instructions.
Note: for the numeric code selection of steps 3, 4, and 5 use the table at the
end of this Quick Reference.
Restore Dragon™ M Default
1.
Ì$+$*oÎ
Enter Configuration
2.
Ì$+;Î
Set Date
3.
ÌIA%Î
+
six digits for Day, Month and Year (DDMMYY).
Set Time
4.
ÌIB'Î
+
four digits for Hours and Minutes (HHMM).
Set Radio Address
5.
ÌRA0RFHÎ
+
four digits for the Dragon™ M Address
(from 0000 to 1999).
All readers used in the same area must have different addresses.