Press the button Discover or digit the IP address manually, then press Connect.
After that, a message Waiting for connection will be shown.
If the link did not succeed the following window will be shown:
Check the electric connections and the correct operation of the light grid.
After the connection the graphic on the left side will show:
the beams and the form of the object
the TEACH-IN stored in the receiver
two indicators with the measures ( what represent depends on the programming mode)
The bars which represent the light grid will automatically resize themselves on the basis of the
beam number. At this point the button Configure becomes active and the button Connect becomes
Disconnect.
Fig. 10
To Next Page
Loading...
