Programming
16
GRYPHON™ I GD4500
★ = default value
* Supports only the interfaces listed in the Country Mode feature description.
PROGRAMMING
The reader is factory-configur
ed with a set of standard
default features. After scanning the interface bar code from
the Interfaces section, select other options and customize
your reader through use of the programming bar codes avail
-
able in the Gryphon™ I GD4500 PRG. Check the correspond-
ing features section for your interface, and also the Data
Editing and Symbo
logies chapters of the PRG.
Using Programming Bar Codes
This manual contains
bar codes which allow you to reconfig-
ure your reader. Some programming bar code labels, like the
"Reset Default Settings" on
page 17, require only the scan of
that single label to enact the change.
Other bar codes require the reader to be placed in Program-
ming Mode prior to scanning them. Scan an ENTER/EXIT bar
code once to enter Programming Mode; scan the desired
parameter settings; scan the ENTER/EXIT bar code again to
accept your changes, which exits Programming Mode and
returns the reader
to normal operation.
Configure Other Settings
Additional programming bar codes are available in the
PRG to allow customization of programming features. If
your installation requires different programming than the
standard factory default settings, refer to the PRG.
Resetting Product Defaults
If you are not sure what programming options have been set
in your reader, or you have changed some options and want
your custom factory settings restored, scan the bar code
below to reset the reader to its initial configuration. Refer to
COUNTRY MODE (CONTINUED)
Country Mode = United Kingdom
To Next Page
Loading...
