DATALOGIC
2
CHARGING THE BATTERIES
By placing the reader onto the OM-Gryphon™ cradle or C-Gryphon™ battery
charger it is possible to charge the Gryphon™ M batteries. Make sure the
charging LED goes on.
The LEDs positioned on the cradle signal the charge status, as described in the
following table:
LED STATUS
Power on /
Data
Yellow On = OM-Gryphon™ is powered.
Yellow Blinking = OM-Gryphon™ receives data and
commands from the Host or the reader.
Charging
Red On = the battery charge is in progress.
Red Blinking = the battery reconditioning is in progress.
Charge
completed
Green On = the battery is completely charged.
Charging +
Charge
completed
Red and Green Blinking together = the reader is not
correctly placed onto the reader.
D
I
S
C
H
A
R
G
E
After many
recharging cycles NiMh and NiCd batteries may tend to lose their
operating autonomy. This condition can be overcome by positioning the
Gryphon™ M onto the OM-Gryphon™ / C- Gryphon™ charger and pressing the
“battery reconditioning” button.
Power on / Data
(yellow LED)
Reconditioning battery
button
Charging
(red LED)
Charge completed
(green LED)
To Next Page
Loading...
Need help?
General
