DATALOGIC
4
Exit and Save configuration
4.
Ì$-?Î
5.
Read the Bind code to pair the Gryphon™ M to the OM-Gryphon™
cradle.
The reader is dedicated to the cradle. Any previously bound reader will
be excluded.
To connect several readers to the same cradle see the following section
"Using Multiple Readers with Same Cradle".
Bind
Ì$+RN0$-IÎ
The green LED on the Gryphon™ M will blink: the reader is ready to be
positioned onto the cradle.
6.
Firmly position the reader onto the cradle within 10 seconds, a beep will
be emitted, signaling that the OM-Gryphon™ cradle has been paired to
the Gryphon™ M, and the green LED on the reader will go off.
YOUR READER IS NOW CONFIGURED TO READ CODES USING THE
DEFAULT VALUES.
7.
Configure the OM-Gryphon™ cradle; refer to the “OM-Gryphon™ Quick
Reference Guide”.
Green LED
To Next Page
Loading...
Need help?
General
