Datalogic Jet DH60 - Imager Data Capture

USE AND FUNCTIONING
29
4
4.3.2 Imager Data Capture
The DH60 Imager captures a picture of the entire bar code. The omni-directional
scanning does not require that the operator orient the bar code to align with the scan
pattern.
To read a 1D or 2D code, simply point the DH60 Imager model onto the code and
press the SCAN Key or the pistol trigger.
The DH60 Imager uses an intelligent aiming system pattern, similar to those on
cameras, indicating the field of view, which should be positioned over the code:
Aiming System
If the aiming system pattern is centered over the entire symbology as shown in the
following figure, either wait for the timeout or release the Scan key or the trigger to
capture the image.