Datalogic Magellan 800i

Quick Reference Guide 1
Quick Reference
Use the Quick Reference Guide (QRG) to find easy connection, scan-
ning and troubleshooting instructions. For more details, including
programming information, reference the Product Reference Guide
(PRG), which is available for download, viewing and printing from
the Datalogic website listed on the back cover of this manual.
Installation
Route the interface cable from the terminal or host. Plug the AC
adapter (if one is used) into a wall outlet and the interface (I/F)
cable, then route and attach the I/F cable to the scanner. Verify
operation by presenting known-good bar codes to the scanner. The
unit should beep
1
and/or flash its good read LED and send the bar
code data to the host or terminal. If not, refer to
Troubleshooting
on page 5
of this guide.
Scanner installation is complete.
1. Beeper and LED behavior is selectable and may have been disabled by
a previous user.
I/F Cable
A/C Adapter
(if needed)
For 220-230 VAC
adapters, the
cord must be
facing down as
shown in the
illustration. If
installed upwards,
it will pose an
undue strain on the
socket outlet.
To Host/Terminal
Connect
Here