Datalogic Matrix 400 Quick Reference Guide

MATRIX 400™ QUICK GUIDE
14
APPENDIX
X-PRESS™ is the intuitive Human Machine Interface designed to improve ease of installation and maintenance.
Status and diagnostic information are clearly presented by means of the five colored LEDs, whereas the single
push button gives immediate access to the following relevant functions:
• Test with bar graph visualization to check static reading performance
• Focus/Locate to turn on the Blue Diamonds™ to aid focusing and positioning.
• Setup to perform Exposure Time and Gain calibration.
• Learn to self-detect and auto-configure for reading unknown codes
In normal operating mode the colors and meaning of the five LEDs are illustrated in the following table:
READY (green) This LED indicates the device is ready to operate.
GOOD (green) This LED confirms successful reading.
TRIGGER (yellow) This LED indicates the status of the reading phase.
COM (yellow) This LED indicates active communication on main serial port.
STATUS (red) This LED indicates a NO READ result.
During the reader startup (reset or restart phase), all the LEDs blink for one second.
On the connector side of the reader near the cable, the blue POWER ON LED indicates the reader is correctly
powered.
For Ethernet models, on the connector side of the reader near the Ethernet connector, the orange NETWORK
PRESENCE LED indicates Ethernet network connection.

Datalogic Matrix 400 Specifications

General

Brand	Datalogic
Model	Matrix 400
Category	Laboratory Equipment
Language	English