What to do if Datalogic P2x Digital Camera data transferred to the host are incorrect?
If the data transferred to the host are incorrect, corrupted, or incomplete, verify that the host IP address settings are the same as the camera settings. Also, check if the Gigabit Ethernet cable is intermittent.
What to do if Datalogic Digital Camera is not transmitting anything to the host?
If the camera is not transmitting anything to the host, ensure the Gigabit Ethernet cable wiring is correct and connected. Also, verify that the host IP address settings are compatible with the camera settings.
How to fix Datalogic Digital Camera if power LED is not lit?
If the POWER LED is not lit, check the following: • Is the power connected? • If using a power adapter (like PG6000), is it connected to the wall outlet? • If using rail power, does the rail have power? • If using CBX, does it have power (check switch and LED)? Also, check if you are referring to the M16 19-pin connector or the CBX spring clamp connectors. Measure the Voltage either at pin A and pin L (for the 19-pin connector) or at the spring clamp Vdc and GND (for CBX).
What to do if Datalogic P2x is not acquiring images with external trigger?
If a trigger signal is connected to the camera, but it is not acquiring images or running tasks, consider the following: • Check if you are referring to the 19-pin connector or to the CBX spring clamp connectors. • Is the sensor connected to Input 1 or Input 2? • Is power supplied to the photo sensor? • For NPN configuration, is power supplied to one of the two I1 or I2 signals (A or B)? • For PNP configuration, is one of the two I1 or I2 signals grounded (A or B)? • Are the photo sensor LEDS (if any) working correctly? • Is the sensor/reflector system aligned (if present)? In VPM, check the Debounce settings (Settings – General – Communication). Also, ensure the camera is online.
How to find serial number of Datalogic Digital Camera?
The camera Serial Number consists of the letter “C” followed by a series of numbers. It is printed on the rear of the camera.
General| Frame Rate | Up to 60 fps |
|---|---|
| Sensor Type | CMOS |
| Interface | GigE Vision |
| Operating Temperature | 0°C to 50°C |
| Storage Temperature | -20°C to 70°C |
| Field of View | Depends on lens |
To Next Page
