Datalogic PowerScan PBT950X

DEFAULT
$CPWES0000\r
F4 No Actions Configured
$CPWES
Configure Actions for F4
To configure this feature, scan the ENTER/EXIT PRO-
GRAMMING MODE bar code above, then the bar code
for
the Function Key you want to program. Next scan
4 digits from the Alphanumeric characters in
Appen-
dix D, Keypad
.
The first digit must be 0; the following 3 digits must
be confi
gured according to the CMD_ID numbers in
Table 27 on page 251 . End by scanning the
ENTER/EXIT bar code again.
Enter/Exit Programming Mode
254 PowerScan™ PD953X/PBT950X/PM950X
Configure Actions for F4 (16-key models only)
DEFAULT
$CPWEQ0000\r
Shift No Actions Configured
$CPWEQ
Configure Actions for Shift
To configure this feature, scan the ENTER/EXIT PRO-
GRAMMING MODE bar code above, then the bar code
for
the Function Key you want to program. Next scan
4 digits from the Alphanumeric characters in
Appen-
dix D, Keypad .
The first digit must be 0; the following 3 digits must
be confi
gured according to the CMD_ID numbers in
Table 27 on page 251 . End by scanning the
ENTER/EXIT bar code again.
Configure Actions for Shift (16-key models only)