Operating Modes
QUICK REFERENCE GUIDE
17
Stand Mode —
The scanner looks for changes within its
field-of-view. The Aiming Pattern is always on to show the
optimum reading area. If a predefined amount of move-
ment is detected, the white illumination switches on. Scan-
ning continues until a label is read or “Scanning Active
Time” is reached.
Retained Trigger Hold Multiple —
Same as Trigger Hold
Multiple but all decoded labels are transmitted when the
trigger is released. The labels can be sorted before trans-
mission.
Default value
2. Controlled by Flash On Time and Flash Off Time. Use the PRG to pro-
gram these options.
SCAN MODE
ENTER/EXIT PROGRAMMING MODE
Scan Mode = Trigger Single Scan Mode = Trigger Pulse Multiple
Scan Mode = Trigger Hold Multiple
Scan Mode = Flashing
Scan Mode = Always On Scan Mode = Stand Mode
Scan Mode= Retained Trigger Hold Multiple
To Next Page
Loading...
