Datalogic PowerScan PM9501 Series User Manual

Installing the Battery Pack
6 PowerScan™ PM9501
Charging the Batteries
Once the BC 90x0 is powered, you can charge the reader's
batteries. Place the PowerScan
™
M9501 into the BC 90x0
cradle. The Reader LED on the cradle/battery charger
turns red. The battery is completely charged when the
Reader LED on the cradle/battery charger turns green.
The battery can also be charged in the spare battery slot
(BC91xx models only) or using the Multi Battery Charger
accessory.
Changing the Batteries
1. Push the button at the bottom of the handle as
shown to release the battery.
2. Pull down to remove the battery.
Do not incinerate, disassemble, short termi-
nals or expose to high temperature at risk of
fire, explosion. Use specified charger only. Risk
of explosion if the battery is replaced by incor-
rect type. Dispose of batteries as required by
the relevant laws in force.
WARNING
Button
1
2

Datalogic PowerScan PM9501 Series Specifications

General

Scanner Type	Handheld
Connectivity	Wireless
Drop Resistance	Withstands repeated drops from 2.0 m / 6.6 ft onto concrete
Sealing	IP65
Operating Temperature	-20 to 50 °C / -4 to 122 °F
Type	Industrial
Storage Temperature	-40 to 70 °C / -40 to 158 °F
IP Rating	IP65
Radio Range	100 m / 328 ft
Radio Frequency	433 MHz; 910 MHz
Decode Capability	1D / 2D
Scanning Technology	Laser or Imager
Interface	RS-232, USB
Supported Barcodes	All standard 1D and 2D barcodes
Resolution	4 mil (1D Codes); 5 mil (2D Codes)
Humidity	5 to 95% (non-condensing)
Drop Specification	2.0 m / 6.6 ft onto concrete
Dimensions	8.3 x 4.3 x 2.9 in
Power Supply	Rechargeable Li-ion battery or USB power