Cleaning Procedure
34
QUICKSCAN™ 2500
software, and computer systems and can provide individu-
alized assistance.
CLEANING PROCEDURE
Exterior surfaces and scan windows exposed to spills,
smudges or debris accumulation require periodic cleaning
to ensure best performance during scanning operations.
Follow the procedures described in this instruction sheet
to keep your QuickScan device in good operating condi-
tion.
Common Cleaning Solutions
The cleaners and disinfectants listed below are recom-
mended for use on Datalogic’s Quickscan 2500 Enclosures:
WARNING: Be sure to turn off power and unplug
the device from electrical outlet before cleaning.
CAUTION: DO NOT use abrasive pads or cleaning
agents.
CLEANERS DISINFECTANTS
Formula 409® Glass and
Surface Cleaner
Clorox® Bleach (diluited 10:1)
70% Isopropyl Alcohol Hydrogen Peroxide 3%
Windex® Multi-Surface
100% Gentle dish soap
an
d water
NOTE: Disinfectants may be harsh on metal. They
are recommended for use only on enclosures.
CAUTION: DO NOT spray or pour cleaner directly
onto the unit.
DO NOT use solutions in their concentrated form.
DO NOT use aerosols, solvents or abrasives.
DO NOT use paper towels or rough cloths to clean
windows.
To Next Page
Loading...
Need help?
General
