Datamars ISO MAX V - Set-Up; Reading Beeps; Key Beep; Reading Timeout

ISO MAX V Manual – v. 1.2 – july 2012 10
3.5 Set-up
There are various features in the ‘set-up’ menu.
The following figure shows the ‘set-up’ menu:
KEY BEEP OFF
SET-UP
READING BEEPS OFF
READING TIMEOUT 10s
SHUTDOWN TIMEOUT
2m
SERIAL BAUD RATE 115k
You can scroll through the ‘set-up’ features by pressing the UP or DOWN button. You can
change the highlighted parameter by pressing the LEFT/RIGHT button.
3.5.1 Reading beeps
The reading beep feature enables or disables the acoustic signal when a TAG is found. When
the reading feature is OFF the beep is disabled, while it is ON the beep is enabled.
3.5.2 Key beep
The key beep feature enables or disables the acoustic signal when a button is pressed. When
the key feature is OFF, the beep is disabled. When it is ON, the beep is enabled.
3.5.3 Reading timeout
The reading timeout is the maximum period of time that the reader scans for a TAG. After this
period, the reader switches from reading mode to idle mode automatically, showing the
message “NO TAG FOUND”.
3.5.4 Shutdown timeout
The shutdown timeout is the maximum period of time that the reader stays on while no buttons
are pressed. After this period the reader switches off automatically.
3.5.5 Serial baud rate
This parameter sets the speed of the serial communication through the USB interface. This
parameter must be the same in the reader and on the PC program that attempts to receive data
from the reader.