ISO MAX V Manual – v. 1.2 – july 2012 30
• Command action: downloads and installs the up-dated firmware version.
• Parameter range: none.
Description: this command allows the user to update the firmware of the reader. First of all you need a
new firmware file (isomax5_1V1.hex). Then type the command and follow the online instructions.
10.1.38 Sets the default parameters
• Command syntax: “.DP” [CR]
• Command answer: [LF]
• Command action: sets the default parameters.
• Parameter range: none.
Description: this command sets the default parameters.
11 Certifications
FCC Part 15
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) This device must accept any
interference received, including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for Class B Digital Device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates and can radiate
radio frequency energy and, if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no guarantee that interference will
not occur in a particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna
• Increase the separation between the equipment and receiver
• Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected
• Consult the dealer or an experienced radio/TV technician for help
Any changes or modifications not expressly approved by the party responsible for compliance could
void the user’s authority to operate the equipment.
Canadian directives
This Class B digital apparatus complies with Canadian ICES-003.
Cet appareil numérique de la classe B est conforme à la norme NMB-003 du Canada.
European directives
Hereby, Datamars SA via ai Prati 6930 Bedano-Lugano (CH) declares that the ISO MAX V is in
compliance with the essential requirements and other relevant provisions of Directive 1999/5/EC.
To Previous Page
Loading...