Datamax I-Class Mark II I-4212E/203 - System Settings

Chapter 4 – Menu System 42
RIBBON LOW Sets the type of output signal generated to indicate Ribbon Low condition where:
ACTIVE LOW Outputs a logic low upon condition.
ACTIVE HIGH Outputs a logic high upon condition..
SLEW ENABLE Selects the type of input signal required to initiate label slew, where:
STANDARD Triggers slew with a low signal.
LOW PULSE Triggers slew with a low pulse.
HIGH PULSE Triggers slew with a high pulse.
ACTIVE LOW Triggers slew with a low signal.
ACTIVE HIGH Triggers slew with a high signal.
Err On Pause
(App2)
Sets the output when a service required fault occurs (Applicator Interface Card
Type 2 equipped only), where:
ENABLED Enables the output signal.
DISABLED Disables the output signal.
System Settings
The System Settings menu contains label formatting, operation, and control functions:
 Menu Mode
 Configuration File
 Internal Module*
 Default Module*
 Scaleable Font Cache*
 Single Byte Symbols*
 Double Byte Symbols*
 Time And Date
 Media Counters*
 Print Configuration*
 Configuration Level*
 Set Factory Defaults*
 Format Attributes*
 Label Rotation
 Imaging Mode*
 Pause Mode*
 Peel Mode*
 Security*
 Units Of Measure*
 Input Mode*
 DPL Emulation*
 Column Emulation*
 Row Emulation*
 SOP Emulation*
 Back After Print*
 Font Emulation*
 Label Store*
 Menu Language
 Display Settings*
 Fault Handling*
 SCL Font Bold Factor*

Items denoted with an asterisk (*) are only accessible through the Advanced Menu.
The menu selections are defined as follows: