Datamax I-Class Mark II I-4212E/203 - Page 57

Chapter 4 – Menu System 51
DISPLAYED ITEM ITEM DESCRIPTION
WIRED
ETHERNET
Controls the communications settings for the wired Ethernet network interface
IP
DISCOVERY
Sets the address discovery method, where:
USE STATIC
ADDRESSES
The stored static IP, Subnet Mask, and / or Gateway Address will be used.
USE DHCP The card broadcasts over the network using DHCP protocol to receive addresses
from the responsible server at startup. Manual modifications to IP Address, Subnet
Mask, or Gateway Address are not allowed; and, if no server is found, the specified
static value will be used. (Default Setting)

A server assigned IP address takes precedence over any static IP
address stored in the interface.
USE BOOTP
The card broadcasts over the network using BOOTP protocol to receive addresses
from the responsible server at startup. Manual modifications to IP Address, Subnet
Mask, or Gateway Address are not allowed; and, if no server is found, the specified
static value will be used. (Default Setting)

A server assigned IP address takes precedence over any static IP
address stored in the interface.
IP ADDRESS Specifies the static IP Address of the interface in the standard octet format.
SUBNET
MASK
Specifies the static Subnet assigned to the interface, for
example:255.255.255.000.
DEFAULT
GATEWAY
Specifies the Gateway Address the interface will use, for example:192.168.10.1
DUPLEX
CAPABILITY
Specifies the transmission and speed of the wired Ethernet connection:
• Auto-Negotiate (default);
• 100 BaseT Full Duplex;
• 100 BaseT Half Duplex;
• 10 BaseT Full Duplex; or,
• 10 BaseT Half Duplex
PRIMARY
WINS SERVER
The IP address of the primary WINS Server.
SECONDARY
WINS SERVER
The IP address of the secondary WINS Server.
PRIMARY DNS
SERVER
The IP address of the primary DNS Server.
SECONDARY
DNS SERVER
The IP address of the secondary DNS Server.
SNMP TRAP
DESTINATION
ADDRESS
Is the address in standard octet format where SNMP traps will be sent when SNMP
service is installed on your receiver. When zeroed, no traps are sent.
SNMP SERVER
ADDRESS
Is the server address in standard octet format for SNMP services.
NETBIOS
ENABLE
Enables or disables the NET BIOS SERVICES
NO (Default Setting)
YES