Datatool S4 Series - Table of Contents; Transmitter Learn;Customer Software Switches Annex

2
Index
S4 installation
Technical specifications Page 3
Specifying the system Page 4
The Datatool website
Pre installation checks Page 5
Stripping the machine Page 6
Planning the installation Page 6-8
The S4 installation tester (fitting the alarm harness) Page 9-13
What the wires do Page 14-21
Combining the ignition key with the remote control Page 22/23
S4 Operation
Credit card (Quick start) instructions Page 24
S4 Operating Guide
Welcome/Registering the system
The unique internal transponder ID tag Page 25
The remote control
Combining the ignition key with the S4 remote control Page 26
Changing the remote control battery S4 Red and Green Page 27
Changing the remote control battery S4 Yellow Page 28
Arming the system
Passive arming
Fully arming
Ferry mode Page 29
Disarming the system
Disarming the system
Disarming the system after it has been triggered
Silent arming/disarming
Automatic re-arming Page 30
Sleep mode
Hazard warning lights
Panic locator feature Page 31
The PIN override system
Entering a new PIN code
Changing the PIN
Disarming the system with the PIN Page 32/33
Adding extra remote controls Page 34
Customising the system (Customer switches)
Siren tone
Passive arming settings (Passive immobiliser or Full passive arming) Page 35
Customising the system (Engineers switches)
Engineer switch entry Page 36
Engineer switch table Page 37
Transmitter erase
Return to factory defaults
System diagnostics
Movement sensor adjust
Nudge sensor adjust
Arming tones On/Off
Panic On/Off
Selecting type of nudge Page 37 - 41
Extending the security
Extra siren/Pager output
Covering accessories
Garage security Page 42
How to remove the machine’s battery/winter mode Page 43
Service support Page 44 - 52
Fault finding as simple as ABC Page 44 - 46
Current usage Page 47
False alarms Page 48/49
Running faults Page 50
Transmitter problems Page 51
The Dattrac warranty returns system Page 52
PIN learn procedure Annex 1
Transmitter learn/customer software switches Annex 2
Engineer’s software switches Annex 3
Immobilisation techniques Annex 4
S4 wiring diagram Annex 5