DAVID 5 - SL Scanning Process

10/31/2016 DAVIDDAVID5Manual
http://www.david3d.com/en/support/david5/printversion 22/37
↑ | Scanning | SL Scanning
Choose scanning mode
There are several scanning modes available:
"Single Scan" mode
In the SingleScan mode, the most recent scan is kept and shown in the "Scanning" menu. The Scan Result
parameters can be adjusted on that scan and it needs to be added to the List of Scans manually. Click on
the Scan button to start a scan.
"Automatic Turntable" mode
The AutomaticTurntable mode can be used for automatic scanning with the DAVID TT-1. After connecting
the turntable, select the desired total scan angle and desired number of scans. Below, the rotation
between scans will be shown. Click the Scan button to start a scan cycle. All scans will be added to the List
of Scans and aligned automatically.
"Manual Scan Sequence" mode
In the ManualScanSequence mode, scans are automatically added to the List of Scans to allow for
performing several scans quickly. Select what kind of motions you will perform with the object from the list,
click on the Scan button to start a scan.