GoIP User Manual
http://www.dbltek.com
incoming calls. If it is set to Busy, then the Host channel will always to be used to answer
an incoming call whenever it is available.
Setting this parameter enables Hunt Group Sharing feature. This parameter must set the
IP of the GoIP which contains the Host channel of the other Hunt Group.
Client- This assigns the selected channel to be a client in Hunt Group mode.
The Host Address field specifies the IP address of the device that contains the Host
channel. If a Client and its Host belong to the same device, its device IP is entered in this
parameter. A client registers and updates its channel status to the Host.
This option is used to block an incoming calls when the condition specified in the Trigger is met.
The block operation is released when an incoming call with a different Caller ID is received.
This sets the number of consecutive calls with the same Caller ID required to trigger the
Incoming Call Block function.
This page defines how incoming calls to each GSM channel are handled. GSM incoming calls can either be
answered and prompted for second dial or forwarded to a phone extension or IVR in the VoIP network
connected. The parameters in the Call In Page are divided into two sections. The top section contact the
parameters that are applicable to all channels and the bottom section are for each channel individually.
Parameter Description Default Value
1. Call In Auth This parameter defines how incoming GSM calls are authenticated before routing calls to the
VoIP network connected. Five options are available:
1. None – No authentication is required; all incoming GSM calls are routed to VoIP.
2. Password – The caller is prompted for entering the password before the call is routed or
a second dial tone is generated.
3. Whitelist – Only calls with caller IDs that are listed on the Whitelist are accepted by the
GSM channel selected. Calls with GSM numbers not on the list are not answered at
To Next Page
Loading...
Need help?
General
