DBL Technology GoIP User Manual

GoIP User Manual
http://www.dbltek.com
50
The procedures to send an USSD command are:
a) Select the Line (GSM channel) that you want to send an USSD command to the service provider.
The line status and the SIM (GSM) number are displayed. The last option "All Lines" means that all
channels are selected and the same USSD command is sent via all channels provided that they are in
the Login Status.
b) Enter the USSD command
c) Click [Send].
Example:
For the service provider PCCW in Hong Kong, the USSD command to check balance is ##122#. Enter
“##122#” and the click [Start]. The following screen is then displayed.
A few seconds later, the service provider sends back a USSD message/response as shown below.
Click [Back] to return to the Send USSD command page.
For certain service requests, user responses are required. Just following USSD message and then send
back a response via SEND USSD command.
3.4.4Send SMS
Click [Send SMS] to access the Send SMS webpage as shown below

DBL Technology GoIP Specifications

General

Brand	DBL Technology
Model	GoIP
Category	Gateway
Language	English