GoIP User Manual
http://www.dbltek.com
Three modes for base station selection are available:
1.Auto - This mode uses the default GSM base selection mechanism.
2.Poll - This mode limits the number and the list of base stations (BTS) that could be selected. Either
Whitelist or Blacklist method can be used for BTS selection.
Description Default Value
This limits the maximum number of channels for polling. 4
This defines the duration in minutes when the next base station switching
should occur. The base station switching only occurs when the
corresponding channel becomes idle.
3. White/Black List Auth There are three ways to define how to switch to a different base station.
If it is disabled, the base station selection cycles through the neighbor list.
If the Whitelist authentication mode is selected, then the channel
selection cycles through the base stations defined in the Whitelist.
If the Blacklist authentication mode is selected, then the channels listed in
the Blacklist will not be selected.
4. Whitelist/Blackllist Whitelist defines the base stations that are going to be used.
Blacklist defines the base stations that are NOT going to be used.
3. Fixed - This mode locks the base station to the Cell ID specified. Select "Fixed" to enable this mode and
then press [Save Changes]. To view the available Cell IDs, please wait couple of minutes and then
refresh the screen then select and enter the desired Cell ID as shown below. Remember to press [Save
Changes] again to save the Cell ID entered.
To Next Page
Loading...
Need help?
General
