DCS F-5E Flaming Cliffs - Procedures; Engine Start

[FLAMING CLIFFS]
DCS
Eagle Dynamics
13
PROCEDURES
Engine start
To start the engines when on the ground, perform the following steps:
1. Power on the battery with the switch on the Right Vertical Console by pressing R.Shift + L
2. Press R.Shift + Home to start the engines. Left engine starts first. Verify that the engines are
in Idle mode, the RPM should be 49 to 52%.
Battery
RPM 49–52%
Oil Pressure
5–20 psi
Exhaust Gas
Temperature
140ºС or greater
Nozzle Position
60–79%
Fuel Flow
around 400 pph