6. Smoothly lower the nose wheel, deploy the drag chute P . Apply brakes W to slow the
aircraft.
7. Exit the runway. Retract flaps F and speed brakes B , (if were extended).
Single-engine approach and landing
1. If unable to maintain the landing speed, jettison stores by successively pressing L.Ctrl+ W .
Use the afterburner mode of the running engine.
2. Extend landing gear G and flaps F on final approach.
3. Approach, descent and landing should be performed at speeds 10 KIAS higher than the
calculated landing speed for the aircraft's landing weight.
4. On final approach, maintain angle-of-attack of 14 units according to the angle-of-attack (AoA)
indicator.
5. Deploy the drag chute P during landing roll if necessary.
Engine shutdown
To shut down the engine perform the following steps:
1. Set throttles to OFF by pressing R.Shift + End .
2. Turn off the battery by pressing R.Shift + L .
To Next Page
Loading...