DCS F-5E Flaming Cliffs - Taxi; Before Takeoff

DCS
[FLAMING CLIFFS]
14
PROCEDURES
Taxi
Press L.Ctrl + C to close the canopy before taxi.
To start taxiing perform the following steps:
1. Slowly advance engine throttle to 65-70% with Numpad+ and Numpad-
2. Engage nosewheel steering by pressing L.Alt + Q . Use pedals ( Z or X ) to turn.
3. Maintain taxiing speed by adjusting throttle and applying main wheel brakes W to prevent a
roll-over. Keep engine RPM at approximately 57%.
Before takeoff
Enter the runway. Roll forward slightly to align the aircraft with the centerline. Apply brakes W to
stop.
1. Press F twice to fully extend flaps, set Thumb Flap switch on the Throttle to AUTO. Flap
Indicator - Verify FULL.
Thumb Flap
Switch
Flap Indicator