3. Deploy the airbrakes B , move the throttle back to idle and dive to the target. The most
convenient way to do this is by rolling upside-down, directing the nose to ground and finishing
with another half-roll pointing the nose to the target.
4. Check the dive angle against the horizon by the angular scale lines drawn on the canopy
glass left and right. For every 5 extra dive degrees, re-calculate the drop altitude by adding an
extra 500 ft. or vice versa for every 5° of decreasing dive angle subtract 500 ft. from the drop
altitude.
5. Level the wings, remove any bank or slip. Place the reticle over the target and press
R.Alt+Space at the required altitude.
6. Pull up immediately after the drop. Retract the airbrake B and push the throttle to exit the
target area.
To Previous Page
Loading...
