Dea SPACE Series - 3 Transmitters learning; 4 Deletion of all transmitters

35
3 Transmitters learning
1. Scroll down the parameters with and
keys until you visualise P005;
2. Conrm by pressing on the
key;
3. When the symbol “
” appears, press on
any key of the transmitter you want to memo-
rize;
4. The display visualizes the number of the trans-
mitter just memorized and then “
”;
5. Memorize all necessary transmitters repeat-
ing this procedure from step 3;
6. Wait 10 seconds before quitting the memori-
zation mode, display shows now “P003“.
Warning: In the case of rolling code remotes,
the receiver can be put into learning mode by
pressing the hidden button on a remote control
previously learned.
Warning: When using personalized transmitters,
after entering P005 the learning of the rst
personalized transmitter is possible only by
pressing its hidden button. Afterwards, only
transmitters personalized with the same
encryption key can be memorized (through the
usual procedure), unless a memory reset is
carried out (P004).
4 Deletion of all transmitters
1. Scroll down the parameters until you visualize P004;
2. Conrm by pressing on the
key;
3. When “
” is ashing, press the key for a few sec-
onds;
4. Release the
key as soon as “ ” stops ashing;
5. All memorized transmitters have been deleted (display
shows again P004).
5 Programming complete
WARNING At the end of the programming procedure, re-introduce Jumper J4, until “- - - -” is shown on the display and close the lid of
the electric box. The automatism is now in stand-by for normal operating commands.
To perform any “Advanced Programming” operations (parameters modication, programming block/release, conguration of inputs
etc..), go to page 36.