6. Unscrew the 2 screw on the handle, fix on the opposite side of the door. Remove the screw on the right fix
piece, attach the left fix piece (from accessory bag) to the door.
7. Remove the right bottom hinge
by removing the 3 screws, then fix
the 3 screw back without hinge.
8. Remove the hinge pin on the
right bottom hinge and reinstall on
the left bottom hinge.
9. Remove the 3 screws from the
left side and fix the left bottom hinge
on the unit.
10. Place the door on the left bottom hinge. With the magnetic gasket
holding the door in place, make sure the door is aligned with the unit, and secure the top hinge on the left
with 2 screws.
11. Open and close both the door several times to confirm the door is positioned correctly and the gasket is
sealed well. If this is not the case, please adjust the door again.
12. Attach the Fix plate back on the right side. Fix the top cover with 2 screw, cover the screw hole with the
Screw hole cover.
13. Wait at least 30 minutes before plugging in the refrigerator to allow the
refrigerant to settle down. Then plug in the unit.
To Next Page
Loading...
