4. The water tank and the ice detecting plate is very
important to keep your ice cube hygienic. Put a mixture of
neutral cleaner and water into a clean water jet, then spray
the inner surface of tank and ice detecting plate. Wipe these
surfaces as far as possible with a clean cloth. And then,
spray the surfaces with clean water, wiping with a dry clean
cloth. Then, drain out the cleaned water in the water tank by
pulling out the water tank’s drainpipe (labeled “H” in the
illustration on Page 5). When all of the cleaned water has
been drained out, reinstall the water tank’s drainpipe.
Suggestion: After cleaning the interior parts and reinstalling to its respective
position, discard the first batch of ice for food safety purposes.
Ice Making Assembly System Cleaning by Using Nu-Calgon Nickle Safe
Ice-machine Cleaner
Minerals that are removed from water during the freezing
cycle will eventually form a hard, scaly deposit in the water
system. Cleaning the system regularly helps remove the
mineral scale buildup. How often you need to clean the
system depends upon how hard your water is. With hard
water of 4 to 5 grains/liter, you may need to clean the system
as often as every 6 months.
1. Turn off the ice maker. Keep the ice maker connected to
the water supply and drainpipe but shut off the water
faucet of main water supply.
2. Open the door and scoop out all the ice cubes. Either discard them or save them in
an ice chest or cooler.
3. Make the cleaning solution by mixing the Nu-Calgon Nickle Safe Ice Machine Cleaner
with water. Use a plastic or stainless-steel container with more than 4 liters of
capacity. Mix 300 ml Nu-Calgon Nickle Safe Ice-machine Cleaner and 2.8 liters warm
water at about 120℉-140℉.Then, divide them for 2 shares equally in 2 cups. It is
better to keep the same temperature for each cup.
4. Check to be sure that the water tank’s drainpipe has been installed properly in the
slot of the tank wall. Then, pour one cup of Nickel-Safe Ice Maker Cleaning Solution
into the water tank. Wait about for 5 minutes.
5. Turn on the power to the ice maker, then press the “TIMER CLEAN” button on the
control panel for more than 5 seconds to enter the self-cleaning program. The water
pump runs for 8 minutes and stops for 3 minutes and repeats this process for the
total duration time of 30 minutes. During this process, the “CLEAN” light will and the
digit window will indicate the remaining time.
6. After 30 minutes of one self-cleaning program has been completed, pull out the water
WARNING
Wear rubber gloves and safety goggles （and/or face
shield) when handling Ice Machine Cleaner or sanitizer.
To Next Page
Loading...