tank’s drainpipe and drain the cleaning solution down to the lower ice storage bin.
Shake the unit slightly to drain out all the cleaning solution completely. Then, reinstall
the drain pipe to the slot of the water tank.
7. Repeat steps 4--6 to clean the ice making assembly system again.
8. Open the water faucet of the main water supply. Let the water flow into the unit.
Again, press the “TIMER CLEAN” button on the control panel for more than 5
seconds to enter the self-cleaning program. The water pump runs for 8 minutes
and stops for 3 minutes and repeats this process for the total duration time of 30
minutes. During this process, the “CLEAN” light will always be on and the digit
window will indicate the remaining time. Through this process, the machine will
rinse the water dividing pipe, evaporator, water pump, silicone pipe, and water
tank, etc..
9. After one self-cleaning program complete, pull out the water tank’s drainpipe and
drain the cleaning solution down to the lower ice storage bin. Shake the unit slightly
to drain out all of the water completely. Then, reinstall the drainpipe to the water
tank slot tightly.
10. Repeat the step 8-9 again for 2 times.
11. Following the above program to clean the ice storage bin.
12. With this special cleaning program finished, you can return to the regular ice
making mode. We suggest that you discard the first batch of ice cube after cleaning
for safety purposes.
Cleaning Suggestion
1)
DAILY CLEANING
The ice shovel, door and the water dividing pipe should be cleaned per each day. At the end of
every day, rinse the ice shovel and wipe the both sides of the door with a clean cloth.
2)
SEMI-MONTHLY CLEANING
The ice shovel, ice bin, water tank, the ice detecting plate and the surface of the evaporator are
to be cleaned semi-monthly according to interior cleaning program.
3)
SEMI-ANNUAL CLEANING
All the components and surfaces exposed to water or ice cubes, like ice storage bin, water tank,
door, evaporator, water pump, silicone tube, water dividing pipe, etc. should be cleaned by Using
Nu-Calgon Nickle Safe Ice-machine Cleaner every 6 months. They should be
cleaned by the serviceman according to ice making assembly system cleaning program.
The ice machine cleaner contains acids.
DO NOT use or mix with any other solvent-based cleaner
products.
Use rubber gloves to protect hands. Carefully read the material
safety instructions on the container of the ice machine cleaner.
To Next Page
Loading...
