cubes are in the ice-making process, the thicker they will be. Press the “－” button one time and
the ice making time will decrease by one minute. The ice will be thinner if it is in the ice-making
process for less time. Restart the machine it will go back to default “0.”
4.
When the End of Cycle symbol will light up and the machine will stop working when the ice-
making process is complete.
5.
Shut down the unit: After the unit has completed making ice, press the “ON/OFF” button on
the control panel. The unit will shut down and enter standby mode. If you press "ON/OFF" longer
than 5 seconds during ice making, then the unit enters the deicing process directly. This function
can help remove the ice on the ice plate. Press the "ON/OFF" button to shut down the machine.
6.
Timing setting: Setting range： 1-24 hours
• Time shutdown: When the unit is running it can be set shutdown at a
specific time.
• Time on: When the unit is on standby mode, you can set the unit to turn
on with ON-TIMER. Press the TIMER button. The default time is
“1H,” or 1 hour, in the display window. Press the “+” button to
adjust the timer to what you desire. Every time you press the “+” button,
the timer will add 1 hour. Press the “-”button to reduce the timer. During
the process of time adjustment, the “H” in the lower corner of the
number
will
flash. After
5
seconds
without any additional
changes to your
timer,
the
“H”
letter
will
change
from
flashing
to constant, meaning that
the timer has been set.
• In standby mode the unit will display “5H,” meaning that the unit will
start automatically after 5 hours idle.
• In ice making mode the unit will display “5H,” meaning that the machine
will shut down automatically after 5 hours idle. T
• The "H" in the display screen indicates that the machine currently has a
timer set. You will see the time will descend (i.e. 5H, 4H, 3H, and so on)
until the unit turns on or off depending on the mode it is currently set to.
• How to cancel timing: When the unit has a timer, press and hold down the
“TIMER” button. The timer will be canceled after the number on the
screen and "H" are extinguished.
7.
Automatic self-cleaning program. The default cleaning time is 20 minutes.
Start the self-cleaning program: After connecting all the water pipes, plug in the main power
supply plug, then press the “TIMER CLEAN” button on control panel for more than 5 seconds. In
the self-cleaning program, Self-Cleaning symbol will rotate on the display screens. The
time count down display will show 20M. The “CLEAN light will always be on during this period.
The digit window will indicate the left time in the program. The water pump will run for 8 minutes
and stop for 3 minutes and repeat. The total duration time is 20 minutes for one self-cleaning
program. When the water pump stops and the self-cleaning program is complete, the water will
supply the water tank automatically.
Cancel the self-cleaning program: It takes about 20 minutes to complete one self-cleaning
program. When the program is over, the system will be in off-state automatically. You can press
To Next Page
Loading...
