Decobus Handel EX301342AAA - Page 26

obstruons.
 When drainage pipes are installed, ensure that the drainage pipes are properly connected, and are not distorted or
bended.
 While adjusng the upper and lower wind-guide strips of the air outlet, pluck it with hands gently to avoid damaging
wind-guide strips.
 When moving the machine, make sure that it is in an upright poson.
 The machine should stay away from gasoline,mable gas, stoves and other heat sources.
 Don't disassemble, overhaul
and modify the machine arbitrarily, otherwise it will cause a machine malfunon or even
bring harm to persons and propes. To avoid danger, if a machine failure occurs, ask the manufacturer or professionals to
repair it.
 Do not install and use the air condoning in the bathroom or other humid environments.
 Do not pull the plug to turn o the machine.
 Do not place cups or other objects on the body to prevent water or other liquids from spilling into the air cond
oning.
 Do not use inseccide sprays or other mable substances near the air condoning.
 Do not wipe or wash the air condoning with chemical solvents such as gasoline and alcohol. When you need to clean
the air condoning, you must disconnect the power supply, and clean it with a half-wet so cloth. If the machine is really
dirty, scrub with a mild detergent.
 The appliance can be used by children aged from 8 years and above and persons with reduced physical, sen
sory or
mental capabilies if they have been given supervision or instruon concerning use of the appliance in a safe way and
understand the hazards involved. Children shall not play with the appliance. Cleaning and maintenance shall not be made by
children without supervision.
 If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly qualied persons
in order to avoid a hazard.
 The appliance shall be installed i
n accordance with naonal wiring regulaons.
Transportaon, marking and storage for units
1. Transport of equipment containing ammable refrigerants
Compliance with the transport regulaons
2. Marking of equipment using signs
Compliance with local regulaons
3. Disposal of equipment using ammable refrigerants
Compliance with naonal regulaons
4. Storage of equipment/appliances
The storage of equipment should be in accordance with the manufacturer’s instruons
.
5. Storage of packed (unsold) equipment
Storage package proteon should be constructed such that mechanical damage to the equipment inside the package
will not cause a leak of the refrigerant charge.
The maximum number of pieces of equipment permied to be stored together will be determined by local regulaons.
The appliance shall be stored so as to prevent mechanical damage from occurring

01 02 03 04 05 06 07 08 09 10 11 12 13 14 15 16 17 18 19 20 21 22
23 24 25
26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43
44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65