Decobus Handel EX301342AAA - Handling and Transportation; Safety Protections

HANDLING AND TRANSPORTATION
Hold handles on side panels to move the unit in upright poson.
NOTE:

Do not hold the louver.

Make the unit in the upright poson whatever handling or moving it.

Drain the water in the unit completely to prevent water leakage and wet the or or carpet before handling or moving
the unit.
SAFETY PROTECTIONS
1. Water-full safety alarm and shut – o protecn func
When the water volume exceeds its alarm level in chassis, wa
rning sounds automay and water-full icon is lighng in LCD
display, you need to drain the condensate and re-start the unit. (For more informaon about how to drain, refer to the
“Drainage Instruon” please). If the unit is not shut down manually, the unit will recover to the original operang status
automay once the water is fully drained. Or connect the power to re-start the unit again.
2. An-frozen protecn funcon
When the ambient temperature Tr22
℃ and the compressor runs connuously for 50 minutes, the compressor will stop
running, and the fan will be forced to run at high speed. The fan speed indicator on the display board can be switched. A
5 minutes, the air condoner resumes normal operaon.
3. Delay protecn funcn of compressor
This unit oers restart proteon to compressor. Except that the compressor may start immediately when the unit is
energizedst e, there is 3-minute delay re-start pron aompressor is shut
down.
4. Coil and room temperature sensor failure
(1) Detect sensor failure at the beginning of power-on or power-on state
(2) When a sensor failure is detected at the beginning of power-on, it will immediately enter the failure state. If it returns to
normal at this me, it will enter the standby state;

01 02 03 04 05 06 07 08 09 10 11 12 13 14 15 16 17 18 19 20 21 22
23 24 25 26 27 28 29 30 31 32 33 34
35 36 37 38 39 40 41 42 43
44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65