User_Manual-PILATUS-V1_2.doc 41/57
10.3 Loading trim files manually
After creating the trim files for a module and a specific x-ray energy you are
able to load them at anytime. This can be done either after the trim scan
glossary has finished or by executing the following command in theTVX
window: get “trim_gls/p2_trim_load.gl”.
The trim files will be loaded and a comparison between loaded trims and
assigned trims is made. If everything has worked correctly you should see
exactly 100 counts per pixel.
Command Description
trimdet N Set all trimbits to N
show setdac Shows the command used to set the DACs
To Next Page
Loading...