Dectron, Inc. March 2012
DSH/DSV/RSH/DBH/RBH Series Dehumidifier Owner’s Manual
T.A.B. Set Optional Cooling-Water Flowswitch
Data subject to change without notice.
200
NOTE: Do not turn this screw without expressed instructions from Dectron.
Adjust the flow switch using only this set-point adjustment screw.
Do not turn any other screws. Do not bend frames.
NOTE: For adjustment ranges, see table in Installation-Piping- Water- or
Fluid-Cooled A/C.
Establish the proper flow rate. See previous page.
CAUTION: If the set-point adjustment screw is turned too far counter-
clockwise, there will be a point of slightly increased resistance to
turning. Beyond this point the screw will break off.
Adjust the flow switch setpoint-adjustment screw until the contacts (C and A)
close reliably for proper flow. Turning the screw clockwise raises the set point.
Turning the screw counter-clockwise lowers the set point.
Test the function of the flow switch several times by starting and stopping the
flow. Be sure that flow closes the switch contacts (C and A) reliably and that
loss of flow breaks the switch contacts (C and A) reliably.
Replace the flow switch cover. If possible and safe to do so, leave the cooling
water flowing.
DECTRON
Units Equipped for Water-Cooled Air Conditioning Only
DRY-O-TRON
®
Port locations may vary.
See the unit port labels.
Sample
Actual location and
appearance may
vary.
Locate the cooling-water flow switch.
Remove and retain the flowswitch cover.
Do not allow objects to fall onto the inner workings.
Remove the jumper that was installed on third page previous.
T.A.B.
To Next Page
Loading...
Need help?
General
