Dedicated Micros Digital Sprite 2 - Appendix A - Resetting the Digital Sprite 2 Using Telnet

Dedicated Micros Page 101
Reset using Telnet
An alternative option for resetting the Digital Sprite 2 is to connect to the unit using telnet.
1. Go to Start -> Run.
2. Enter <telnet <IP address of Server>>.
3. You will be prompted for a username and password (default dm and telnet) and press
return.
4. Type <reset>, the Digital Sprite 2 will reset itself and will not be available for a few minutes.
Appendix A
Note: Echo is enabled on the Digital Sprite 2 for telnet.