Dedicated Micros Digital Sprite 2 - Additional Information; Command Reference List

Page 148 Dedicated Micros
Command Reference List
Command line
Additional Information
Command Description
<ESC> m\Ether_IP\xxx.xxx.xxx.xxx Set IP address of the Digital Sprite 2.
<ESC> m\subnet\xxx.xxx.xxx.xxx Set subnet of the Digital Sprite 2.
<ESC> m\gateway\xxx.xxx.xxx.xxx Set gateway of the Digital Sprite 2.
<ESC> m\status Displays the status information or the Digital Sprite 2;
drive information, comm. Ports information, enabled
telemetry, etc.
<ESC> m\serial_mode\comx\disabled
Debug
PPP
Text
Tel e m
This command will allow any of the serial ports to be
set for a specific function.
Replace the x with the port number and select from
the list the option available (refer to the serial port
section of this manual for allocated functionality for
each port).
<ESC> m\security\Eng\Open
Off
Pass
Allows the security password for debug mode to be
enabled (pass)or disable (off) on the Digital Sprite 2.
<ESC> m\security\debug\Open
Off
Pass
Allows the security password for debug mode to be
enabled (pass)or disable (off) on the Digital Sprite 2.
ipcfg Shows the IP address, subnet mask and gateway set
on the Digital Sprite 2.
TCP Ports Displays the active TCP ports supported on the
Digital Sprite 2.