Dedicated Micros Digital Sprite 2 - Watermarking; System Variables

Dedicated Micros Page 93
Watermarking
This option has already been covered in the Configuration section of this
manual; please refer to How to Enable and Configure Watermarking for details
of this option.
System Variable
This page can be used for system diagnostics as it provides a readable
overview of the configuration parameters of the Digital Sprite 2. Any information
that has been configured and stored on the Digital Sprite 2 will be shown on the
file. Typical information is; camera titles, alarm title. It identifies the Value,
Variable Name and the Description.
Note: This information may be useful when contacting Dedicated Micros for system
analysis.
Function Description
Onboard Relays There are six onboard relays, enabling the corresponding relay will
close the output.
Module 1
If an additional relay module has been connected to the 485 bus,
this allows the relevant relays to be tested.
Note: The relay will only be initiated when the Save option has been
selected.
Module 2
If a second additional relay module has been connected to the 485
bus, this allows the relevant relays to be tested.
Note: The relay will only be initiated when the Save option has been
selected.