1.1 CLARIFICATION OF NOTATION
Clarification of notation used within this publication.
Highlights an essential element of a procedure to ensure correctness.
Indicates a procedure or practice, which, if not strictly observed, could
result in damage or destruction of equipment.
Indicates a procedure or practice, which could result in injury to personnel
or loss of life if not followed correctly.
All modules in the DSE6110 MKIII & DSE6120 MKIII range.
Controller Area Network
Vehicle standard to allow digital devices to communicate to one another.
Code Division Multiple Access.
Cell phone access used in small number of areas including parts of the USA and
Australia.
Current Transformer
An electrical device that takes a large AC current and scales it down by a fixed
ratio to a smaller current.
Building Management System
A digital/computer based control system for a building’s infrastructure.
Diesel Exhaust Fluid (AdBlue)
A liquid used as a consumable in the SCR process to lower nitric oxide and
nitrogen dioxide concentration in engine exhaust emissions.
Diagnostic Message 1
A DTC that is currently active on the engine ECU.
Diagnostic Message 2
A DTC that was previously active on the engine ECU and has been stored in the
ECU’s internal memory.
Diesel Particulate Filter
A filter fitted to the exhaust of an engine to remove diesel particulate matter or soot
from the exhaust gas.
Diesel Particulate Temperature Controlled Filter
A filter fitted to the exhaust of an engine to remove diesel particulate matter or soot
from the exhaust gas which is temperature controlled.
Diagnostic Trouble Code
The name for the entire fault code sent by an engine ECU.
Engine Control Unit/Management
An electronic device that monitors engine parameters and regulates the fuelling.
Failure Mode Indicator
A part of DTC that indicates the type of failure, e.g. high, low, open circuit etc.
Society of Automotive Engineers (SAE) J1939 standard is the vehicle bus
recommended practice for communication and diagnostics among vehicle
components.
Sub section of J1939 standard. The parameters and parameter groups contained
in this sub section are predominantly associated with generators and driven
equipment in electric power generation and industrial applications.
To Next Page
Loading...
Need help?
General
