5 Homedepot.ca
Please contact 1-866-308-3976 for further assistance.
Installation
1
Determining the mounting
location
NOTE: The light xture should be mounted approximately
8 ft. (2.4 m) above the ground.
□ Determine the mounting location – wall mount
only.
□ Position the lamp heads (A) in the general
direction of the desired light coverage.
Wall Mount
2
Removing the mounting plate
NOTE: This xture comes with a mounting plate (D). It is
pre-assembled on the light xture (B) for shipping.
□ Unscrew the two decorative screws (CC)
connecting the light xture (B) to the mounting
plate (D) and remove the mounting plate (D)
using the pull loop.
3
Installing the mounting bracket
WARNING: Turn the power off at the circuit breaker or
fuse. Place tape over the circuit breaker switch and verify
power is off at the light xture.
NOTE: Four mounting bracket screws of various sizes are
included. The installation will only require two. Discard the
unused mounting bracket screws after installation.
□ Remove the existing light xture.
□ Install the mounting bracket (FF) using the
mounting bracket screws (AA or BB) that best
t the junction box.
□ Firmly pull on the mounting bracket (FF) to
verify it is securely mounted to the junction
box. If necessary, use the screws that were
removed from the existing light xture.
A
CC
D
B
AA or BB
FF
C
To Next Page
Loading...
