EasyManuals Logo

Defy DHD398 User Manual

Defy DHD398
20 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #10 background imageLoading...
Page #10 background image
Page 10
Installation and connection
The product must be installed in accordance
with all local gas and electrical regulations.
The connection must comply with national
regulations.
The mains supply data must correspond
to the data specified on the type label of
the hob.
The power cable of your hob must comply
with the values in "Technical specifications"
table.
DANGER:
Before starting any work on the
electrical installation, disconnect
the product from the mains supply.
There is the risk of electric shock.
DANGER:
The product must be connected to
the mains supply only by an
authorised and qualified person.
The product's warranty period
starts only after correct
installation. Manufacturer shall not
be held responsible for damages
arising from procedures carried
out by unauthorised persons.
DANGER:
The power cable must not be
clamped, bent or trapped or come
into contact with hot parts of the
product. A damaged power cable
must be replaced by a qualified
electrician. Otherwise, there is risk
of electric shock, short circuit or
fire!
Electrical connection
Connect the hob to a grounded outlet/line
protected by a fuse of suitable capacity as
stated in the "Technical specifications" table.
Have the grounding installation made by a
qualified electrician while using the hob with
or without a transformer. Our company shall
not be liable for any damages that arise due
to using the hob without a grounding
installation in accordance with the national
regulations.
Connecting the power cable
1. If a power cable is not supplied together
with your product, a power cable that you
would select from the table in accordance
with the electrical installation at your home
must be connected to your product by
following the instructions in cable diagram.
This product must only be connected by a
qualified electrician such as a technician
from the local electricity company to a
suitable double-pole control unit with a
minimum contact clearance of 3 mm in all
poles. Failure to obey this instruction may
cause operational problems and invalidate
the product warranty.
480mm

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Defy DHD398 and is the answer not in the manual?

Defy DHD398 Specifications

General IconGeneral
BrandDefy
ModelDHD398
CategoryHob
LanguageEnglish

Related product manuals