Deif MTR-3 - Safety warnings and instructions for use; Waste disposal

To Next Page

To Previous Page

MTR-3 Installation Instructions

DEIF A/S Page 5 of 51

Safety warnings and instructions for use

Check the following before switching on the device:

• Nominal voltage

• Proper connection of auxiliary supply

• Nominal frequency

• Voltage ratio and phase sequence

• Current transformer ratio and terminals’ integrity

• Protection fuse – recommended maximal external fuse size is 6 A

• Proper connection of I/O modules

Waste

It is forbidden to deposit electrical and electronic equipment as municipal waste. The

manufacturer or provider shall take waste electrical and electronic equipment free of charge. The

complete procedure after lifetime should comply with the Directive EZ 2002/96/EG about

restriction on the use of certain hazardous substances in electrical and electronic equipment or a

corresponding Url 118/04.

The secondary output of the current transformer should be short-circuited before

connecting the transducer.