Need help?Do you have a question about the Deister electronic proxSafe flexx and is the answer not in the manual?
Guides the installation of the proxEntry card reader into the proxSafe terminal housing.
Details steps to prepare the terminal bracket for left-side mounting on the flexx housing.
Explains how to open the front and service doors of the proxSafe flexx housing.
Provides instructions on how to change the door orientation for the locking cylinder.
Describes the process of mounting the proxSafe terminal to the flexx housing.
Outlines the steps for securely mounting the proxSafe flexx housing to a wall.
Provides specific dimensions and guidance for wall mounting the flexx 6U housing.
Details dimensions and instructions for wall mounting the flexx 12U housing.
Offers dimensions and guidance for wall mounting the flexx 24U housing.
Explains the critical step of connecting the external wall power supply to the system.
Guides the mounting of keyPanels into the service door of the flexx housing.
Covers operating the flexx system without a proxSafe terminal using jumper settings.
Details the process of installing an Ethernet adapter for network connectivity.
Step-by-step guide to install the Digi Connect ME® adapter onto the backplane PCB.
Explains network connection setup when using a proxSafe terminal.
Details network connection setup when not using a proxSafe terminal.
Covers operating the flexx system without an Ethernet network using a USB adapter.
Describes connecting a PC to the proxSafe terminal using a USB adapter.
Explains connecting a PC to the proxSafe terminal via the backplane PCB.
Guides PC connection to the backplane PCB without a proxSafe terminal.
Details how to connect keyPanels to the flexx backplane PCB.
Explains how to establish a connection between the terminal and the backplane PCB.
Guides the connection of LEDs on top of the flexx housing to the backplane PCB.
Details connecting the door contact to the flexx backplane PCB for door status feedback.
Explains the installation and activation of internal and external tamper switches.
Guides the connection of the power supply unit and the back-up battery.
Describes how to connect additional flexx housings for system expansion.
Final step to close the service and front doors of the flexx housing.
Details the automatic self-test procedure the terminal performs upon power-up.
Guides the process of creating an administrator card for system management.
Explains how to address individual flexx housings within the system.
Covers the procedure for teaching in new keyTags into the system.
Describes how to perform test operations after system configuration.
General| Category | Protection Device |
|---|---|
| Model | proxSafe flexx |
| Manufacturer | Deister electronic |
| Technology | RFID |
| Security Features | User authentication, Access control, Audit trail |
| Switching Distance | N/A (Key management system, not a sensor) |
To Next Page