V1213, 3.16
3.6. 3D drawing
3.6.1. Start 3D
When you would like to create a 3D drawing, the 2D profile view can be switched to a 3D
drawing. The command icons on the oposite side of the command buttons can be used to
switch views to 2D, 3D and 3D unfolded.
The product, started as a 2D profile, will appear in its 3D view, the surface depth is derived
from the initially programmed length.
The active surface is highlighted in a different colour, the cursor marking the selected bend, is
also highlighted in red.
From this point forward, the drawing can be edited as necessary. Surfaces can be added and
deleted, side and angle properties can be changes and for specific surface properties extra
functions are shown in the drawing screen.
2D view mode, showing the product as a 2D profile
3D view mode, showing the product in 3D
3D unfolded mode, showing the unfolded product as a flat sheet
To Next Page
Loading...
